Stainless mandrel bends

[st_aye]

I am trying to obtain/get made a 67 degree 2d mandrel bend in 31/2” stainless
I have tried everywhere i know of (waiting to hear back from OJZ)
Does anyone know of someone who can do this
Thanks in advance

[Floyd]

You may have to ask on Track Time on FB

[st_aye]

Thanks, i will try there ��

[johnfelstead]

I would expect most of the bespoke exhaust people could help. Give Ryan a call. https://www.reefexhausts.co.uk/

[st_aye]

Thank you
I will contact them

[stevieturbo]

A lot of exhaust places seem to top out at 3" but no doubt there are some out there who can do larger.

Vibrant sell pre-bent pieces though, although whether there are any UK stockists is another matter. You can cut a fair amount of bends from this

https://vibrantperformance.com/catal...ff7c7cbae14512

[st_aye]

Thanks, I had not seen that, the pipe diameter is certainly an issue, also the CLR , most places sell (bought in) tight bends

[stevieturbo]

Goodfabs is another that might be able to

https://www.goodfabs.com/

Although fabrication, pie cuts etc is another option. If it needs to be a very tight radius, you can get fabrication donuts to cut up and weld, although they're more common in aluminium. Not so sure about stainless.